Welcome To The Home Of The Visual FoxPro Experts  
home. signup. forum. archives. search. google. articles. downloads. faq. members. weblogs. file info. rss.
 From: tushar Kanvinde
  Where is tushar Kanvinde?
 Kolhapur, Maharastra
 India
 tushar Kanvinde
 To: Nivedita Joshi
  Where is Nivedita Joshi?
 pune
 India
 Nivedita Joshi
 Tags
Subject: RE: when & where to use flush command?
Thread ID: 269046 Message ID: 269079 # Views: 36 # Ratings: 0
Version: Visual FoxPro 6 Category: Projects and Design
Date: Friday, July 16, 2010 10:37:46 AM         
   


> >
> > You can FLUSH IN Alias FORCE for all affected tables after the END TRANSACTION
> >
> > Regards
> > Tushar
>
>
> Hello Tushar,
>
> Thanks for the solution. I have question about this line "FLUSH IN Alias FORCE"
> Q1: I have used tables like Acctmast,Tran etc. so i have to use flush command like this?
> FLUSH IN Acctmast FORCE
> FLUSH IN Tran FORCE
>
> Q2: What is advantage of using this command? Will this command help in table or form corruption when the form is in run mode & there is record going to save into table & if power goes off?
>
> Thanks you again
>
> Regards,
> NIVEDITA

1. Yes. That is how you give the command
2. Yes. It should help towards decreasing table corruption

Regards
Tushar

ENTIRE THREAD

when & where to use flush command? Posted by Nivedita Joshi @ 7/16/2010 8:53:00 AM
RE: when & where to use flush command? Posted by tushar @ 7/16/2010 9:12:29 AM
RE: when & where to use flush command? Posted by Nivedita Joshi @ 7/16/2010 10:20:45 AM
RE: when & where to use flush command? Posted by tushar @ 7/16/2010 10:37:46 AM
RE: when & where to use flush command? Posted by Anil Sharma @ 7/16/2010 1:35:29 PM